- The wire clips secure the installed wiring.
- Mount using BC25 wall clips (art. no. AT5600).
- Stackable.
- Internal dimensions: 23 x 8 mm
- Mount using BC25 wall clips (art. no. AT5600).
- Stackable.
- Internal dimensions: 23 x 8 mm
- Mount using BC25 wall clips (art. no. AT5600).
- Stackable.
- Internal dimensions: 23 x 8 mm
- Quick installation due to attachment holes in 'double' bottom.
- Alignment correction possible thanks to slot and hole pattern in bottom.
- Internal dimensions: 23 x 8 mm
- Quick installation due to attachment holes in 'double' bottom.
- Alignment correction possible thanks to slot and hole pattern in bottom.
- Internal dimensions: 23 x 8 mm
- Quick installation due to attachment holes in 'double' bottom.
- Alignment correction possible thanks to slot and hole pattern in bottom.
- Internal dimensions: 23 x 8 mm
- Quick installation due to attachment holes in 'double' bottom.
- Alignment correction possible thanks to slot and hole pattern in bottom.
- Internal dimensions: 23 x 8 mm
- Wall clips allow 'invisible' attachment of K25 conduit to walls or ceilings.
- A limited degree of change of direction is possible.
- Only suitable for K25.
- The cable clips secure the installed ICT wiring (max. 2 x UTP, FTP or STP).
- This clip makes the installation of ICT-cabling quick and easy.
- Suitable for K25/P25/Z25 conduit.
- 2-pin with rim earthing.
- 16A / 250V with plug-in contacts for solid conductors.
- Consists of base plate with pre-assembled element, cover and mounting hardware.
- Open inlet for flat duct, no separate inlet piece required. Flat duct inlet on other side can be knocked out.
- Integrated stop on base plate for duct and cover.
- Overlaps duct cover by 5 mm. Purely right-angled sawing and sawing to size of the cover is not necessary.
- Knockout in the base plate for rear inlet of duct Ø 16 mm.
- 2-pin with rim earthing.
- 16A / 250V with plug-in contacts for solid conductors.
- Consists of base plate with pre-assembled element, cover and mounting hardware.
- Open inlet for flat duct, no separate inlet piece required. Flat duct inlet on other side can be knocked out.
- Integrated stop on base plate for duct and cover.
- Overlaps duct cover by 5 mm. Purely right-angled sawing and sawing to size of the cover is not necessary.
- Knockout in the base plate for rear inlet of duct Ø 16 mm.